BMG Clone Extruder Kit (Two Trees) — BMG Internals + Push-Fit Fittings + PTFE 300 mm + Clear FEP 1.5 m

Two Trees BMG clone internals plus the fittings, collets, extruder liner and tube that complete the filament path. One bag for a BMG-style extruder rebuild or a new toolhead.

What's in the kit

• 1× Two Trees BMG clone internals kit — stainless dual-drive gears, white 50T reduction gear, shafts, needle bearings, spring and thumbscrew
• 1× PC4-M10 push-fit fitting, black collar — the extruder-side coupler for 4 mm tube
• 2× ECAS04 embedded collet with blue release caps — the toolhead-side tube sockets
• 2× orange collet clips — lock the tube against back-out
• 1× PTFE tube, 2 mm ID × 4 mm OD, 300 mm — the extruder liner: cut it to length for the filament path inside the extruder body. Not every extruder uses a liner, but having it in the bag is what makes this a kit.
• 1× clear FEP tube, 2.5 mm ID × 4 mm OD, 1.5 m — the reverse-bowden run, see-through

Which tube

• Clear FEP shows the filament moving — the multi-material favourite. Same low-friction class as PTFE, slightly stiffer, 260°C.
• Prefer PTFE? The same kit comes with black PTFE or white PTFE in a 2 mm, 2.5 mm or 3 mm bore.

Fits

• Any BMG-style dual-drive extruder body — Voron Clockwork, Afterburner and Mini Afterburner builds and the many printed BMG clones; 1.75 mm filament, 4 mm OD tube.
• Abrasives? The same kits with Runice RNC-coated internals.

Gotchas

• No extruder housing, motor, hotend or fasteners — this is the internals and the filament path.
• ECAS04 needs a housing pocket cut for the embedded collet; the PC4-M10 needs an M10 port.
• Same parts, same shelf as the singles linked above — if the kit reads sold out, one of its parts is.