Phaetus neXt G PT1000 Brass Screw
$3.99
1
More payment options at checkout
Replacement screw-in PT1000 temperature sensor for the Phaetus neXt G hotend. This is the brass M4-style screw sensor used when the original neXt G / Rapido 2-family PT1000 sensor is damaged or you are refreshing the heater-block assembly.
Why this part
- Drop-in service part for Phaetus neXt G hotend temperature sensing, instead of adapting a generic cartridge or glass-bead thermistor.
- PT1000 sensing is used on high-temperature Phaetus hotend builds where the controller firmware and electronics are configured for PT1000 input.
- Threaded brass body seats mechanically in the heater-block sensor position for direct contact and stable readings.
Specifications
- Brand: Phaetus / DropEffect
- Part type: screw-in PT1000 hotend temperature sensor
- Body: brass threaded screw-style sensor body
- Fitment family: Phaetus neXt G / Rapido 2-style screw-in PT1000 sensor installations
- Google category: 3D Printer Accessories
Fitment and setup
Use this as a replacement sensor for a Phaetus neXt G hotend service build. If you are rebuilding the hot side, check the matching Phaetus neXt G heat block and the complete Phaetus DropEffect neXt G hotend listing for the rest of the ecosystem.
Gotchas
- This is not a 104NT / 100K NTC thermistor. Configure firmware and electronics for PT1000, not a generic 3950 or Semitec table.
- Confirm your exact hotend revision uses the screw-in PT1000 sensor before ordering; some newer service sensors use a different non-screw-in form factor.
- After installation, run PID tuning and verify temperature readings at room temperature before heating the hotend.
