KlackEnder Probe by kevinakasam

$9.99 USD
Shipping calculated at checkout.
Material: Black Nickel Coated Stainless Steel

Pickup available at 7723 Paraiso HVN

Usually ready in 24 hours

From the repo:

What is This About?

Adaptation of the Klicky/Quickdraw Probe for the Ender 3 and comparable Creality printers. The probe is compatible with all printers that use the X plate of the Ender 3 and cost of the probe is <10€, of which the switch is the most expensive part. The probe is compatible with Marlin and Klipper. Both firmwares work with the G29 command, the docking is done automatically by the printer, it couldn't be easier! Both firmwares add a KlackEnder menu to the display that can be used to dock and undock the Probe. The Bed-Mesh can be created via the custom menu, via the default firmware settings or with G29.

More info may be found in the repo and extremely well documented on kevinakasam.com.

What's in the Kit?

  • JST-XH 2 Pin Housing x 1
  • JST-XH 3 Pin Housing x 1
  • JST-XH Female Pins x 6
  • M5 T-Nut x 2
  • M2x10 Self Tapping Screws for Plastic x 2
  • M2x12 Self Tapping Screws for Plastic x 2
  • Omron D2F-x Microswitch
  • 1.5m 24AWG FEP Wire
  • Zip-Tie 2x100mm x 3
  • M3x10 BHCS x 1
  • M3x12-16 BHCS x 1
  • M5x8 BHCS x 2
  • M6x3mm Round magnets x 6
  • M5x45 SHCS x 1
4 in stock
Shipping & Returns

Worldwide shipping available. Most items ship within 24 hours. More information may be found on our shipping policy page.

Customer Reviews

Based on 8 reviews

It showed up really good, all you need is the printed parts


Everything was correct. Fast shipping

Really great probe option!

I went from a BL Touch to a KlackEnder, and I really love it! It's simple enough to set up, and is very precise.

The wire was a tad bit short, but I was able to solder it up to the original Z stop cable (and therefore didn't have to worry about putting the JST connectors on anything. I have talked to DFH though, and he said he'd include more wire in future kits so that shouldn't be an issue

joe b

great, i bought two as a test and i'm going to buy 6 more...
just wondering why it only comes with one wire?
and what is the long bolt for?


W packageing
Would be better if came with houseing too
Wire was too short for ender 3 v2

Material: Black Nickel Coated Stainless Steel