EPDM Rubber Feet - Set of 4

Compact EPDM rubber feet for quieter, steadier printer builds. This set of four C-30-RK-3215-style rubber feet gives a Voron or small Printer-for-Ants build a low-profile, vibration-damping base without taking up the larger footprint of oversized machine feet.

Why use these instead of printed feet?

• Better vibration control: EPDM rubber helps isolate motor and motion noise from the table, so the printer is less likely to walk or buzz on hard surfaces.
• Compact footprint: the roughly 32 mm diameter x 15 mm tall body is a good middle ground between tiny V0-style feet and the larger Trident/V2.4 rubber feet.
• Washer-supported mounting: the recessed center washer spreads screw load so the foot can be tightened securely without tearing the rubber.

Specifications

• Quantity: 4 rubber feet — one set is enough for one typical printer.
• Material: EPDM rubber foot with internal metal washer.
• Nominal size: 32 mm outside diameter, 15 mm height; C-30-RK-3215-style form factor.
• Mounting: center screw mount for M5 hardware.
• Hardness: 65° ± 5° Shore, as supplied.
• Use: vibration damping, anti-slip support, and table clearance for compact 3D printer frames.

Fitment

Good for Voron printers and compact Printer-for-Ants builds such as Micron and Salad Fork. If you are building around the Micron Classic Frame, these are the compact rubber feet to use when you want a proper damped base instead of a printed foot. For 1515-extrusion builds, pair with No-Drop Nuts for European Standard 1515 Extrusion when the build calls for captured M5 hardware.

Gotchas

• This listing is for the feet only; frame hardware, screws, and extrusion nuts are not included unless shown elsewhere in your build BOM.
• These are compact feet. If your printer BOM calls for taller/heavier machine feet, check the specified foot size before substituting.
• Compatible C-30-RK-3215-style part, not a Misumi-branded retail pack.