BTT Octopus Pro v1.01 (F429)

$59.99 USD
Shipping calculated at checkout.

Pickup available at 7723 Paraiso HVN

Usually ready in 24 hours

Main Control Chip: The main control board uses 32-bit ARM-level Cortex-M4 series STM32H723ZE/ STM32F429ZE / STM32F446ZE chip with a frequency of up to 168MHz and the flash is 1MB.

Support 60V Input: Supports up to 8 3D printer motherboards with a maximum 60V stepper motor. The motor drive power supply supports up to 60V input (only for the motor drive power supply).

6 Controllable Fans: Up to 6 controllable fans, two normally open fans, and both support power supply voltage, 12V, 5V options.

Update Firmware: Klipper/Marlin/RRF: Supports firmware update via DFU mode. This is where the firmware is sent to the board directly from the PC and does not require a bootloader however this method is not recommended for novice users as discussed later in this document.

Level conversion IC: Supports proximity sensor, jumper optional pull-up resistor, supports more models, supports BL Touch.

4 in stock
Shipping & Returns

Worldwide shipping available. Most items ship within 24 hours. More information may be found on our shipping policy page.