Voron Mods

From the repo: This mod allows for the removal of the panels on a V2, ideal for switching between ABS and PLA printing. This mod assumes a panel depth of...

More information may be found here. 

A recirculating air filter that fits in the tightest of spaces Mounts cleanly under the bed of an F-Zero, Micron, or other smaller-volume, "zero-size" enclosed printer. Heavily inspired by the...

Kit includes: 4x M3x30 SHCS (Full threaded) or M3x40 SHCS (Full threaded) 2x M3x8 or M3x10 4x M3 Washer 4x M5 Washer 4x M3-Inserts 4x F695-2RS bearing 2x 5x18 Pin...

Alternative Idlers that allow the usage of "Full-Figured" toolheads without the 10mm loss of travel at the front corners of the bed.These idlers were developed with the goal to allow...

By, hymness1. More information may be found in the repo. Kit includes: Omron D2Fx (or equivalent) x 2 6x3mm magnets x 8 M2x12mm screws (magnetic) x 2 M3x8mm SHCS x...

Kit includes: 6x3MM Magnet x 2 18 mm M3 screw x 1 18 awg wire x 1m Microfit 2 wire Male connector x 1 Microfit 2 wire Female connector x...

Unklicky is an offshoot of Klicky Probe, which uses magnets instead of an endstop. This is a full Unklicky kit. No extra purchase required. Should you want to try, both, Klicky and...

Unklicky is a sidegrade for Klicky Probe, which uses magnets instead of an endstop. Kit includes: 200mm FEP wire 1 x 3x2mm round magnet Requires Klicky Probe, which may be...

Kit includes: M3x8 SHCS x 2 M3x10 SHCS x 2 M3x40 SHCS x 2 M3 Nut x 2 mg90s/d x 1 6x3mm magnets x 5 300mm servo extension cable 450mm two...

Kit includes: 1 x m3x35 BHCS 2 x m3x20 BHCS 7 x m3x12 BHCS 4 x m3x10 BHCS 5 x m3x8 BHCS 5 x m5x16 BHCS 4 x m5 washer...

Taken from the GitHub repo: V2.4 Z-Drive Motor Tensioner Mod Mod that replaces the motor tensioner assembly in the z drive to make it better braced and eliminates chance to...