LH Stinger Z Shaft Set — 5x72 + 5x50 D-Cut

Both D-cut shafts the LH Stinger Z stack calls for, in one bag: one 5x72mm and one 5x50mm. Straight off the FYSETC LH Stinger BOM (lines 27 and 28, "D shaft 50x5mm" and "D shaft 72x5mm", one each).

Specifications

• Diameter: 5mm, −0.02 / −0.03 (supplier drawing in the photos).
• Flat: 4.3mm across the flat (0.7mm deep), full length.
• Material: stainless steel, bright finish, not hardened.

Not included

• Pulleys, bearings, belts and printed parts. The LH Stinger Motion Kit is the full motion set; the Starter Kit the whole printer.
• Need just one? Both lengths are on the 5mm D-Cut Shaft page, same shafts, same stock.