695-2RS Bearings

10-pack of 695-2RS sealed miniature ball bearings for 5 mm shaft and idler applications in 3D-printer motion systems.

Why use these

• 695-2RS size: 5 mm ID × 13 mm OD × 4 mm wide, the common non-flanged 695 sealed bearing format.
• Rubber sealed on both sides: helps keep grease in and belt dust out.
• 10-pack: enough for small motion rebuilds, idler stacks, spares, and project bins.

Specifications

• Bearing type: 695-2RS miniature deep-groove ball bearing
• Bore / inner diameter: 5 mm
• Outer diameter: 13 mm
• Width: 4 mm
• Closure: 2RS rubber seals, both sides
• Pack quantity: 10 bearings

Fitment and pairing

Use these where your BOM calls for a non-flanged 695-2RS bearing. They are commonly used around 3D-printer belt/idler assemblies, including 9 mm belt paths. Pair with Gates LL-2GT 9 mm RF timing belt for motion rebuilds.

Decision guide

• Need the same 5×13×4 mm bearing with a flange? Use F695-2RS flanged ball bearings instead.
• Need a different 5 mm-bore bearing family? Compare against 625-2RS or F625-2RS before ordering.

What it is not

• Not a flanged F695 bearing.
• Not a linear bearing or rail carriage bearing.
• Not a belt pulley; this is the bearing only.

“Perfect for 9mm belts =D”