dfh.fm
KlackEnder Probe by kevinakasam
Pickup available at 7723 Paraiso HVN
Usually ready in 24 hours
From the repo:
What is This About?
Adaptation of the Klicky/Quickdraw Probe for the Ender 3 and comparable Creality printers. The probe is compatible with all printers that use the X plate of the Ender 3 and cost of the probe is <10€, of which the switch is the most expensive part. The probe is compatible with Marlin and Klipper. Both firmwares work with the G29 command, the docking is done automatically by the printer, it couldn't be easier! Both firmwares add a KlackEnder menu to the display that can be used to dock and undock the Probe. The Bed-Mesh can be created via the custom menu, via the default firmware settings or with G29.
More info may be found in the repo and extremely well documented on kevinakasam.com.
What's in the Kit?
- JST-XH 2 Pin Housing x 1
- JST-XH 3 Pin Housing x 1
- JST-XH Female Pins x 6
- M5 T-Nut x 2
- M2x10 Self Tapping Screws for Plastic x 2
- M2x12 Self Tapping Screws for Plastic x 2
- Omron D2F-x Microswitch
- 1.5m 24AWG FEP Wire
- Zip-Tie 2x100mm x 3
- M3x10 BHCS x 1
- M3x12-16 BHCS x 1
- M5x8 BHCS x 2
- M6x3mm Round magnets x 6
- M5x45 SHCS x 1
Shipping & Returns
Worldwide shipping available. Most items ship within 24 hours. More information may be found on our shipping policy page.
